Technical Data
• 1 Display unit
• 1 Mounting bracket with 2 fixing screws
• 2 m Power supply cable with fuse
• 12 m sensor cable
• 1 Sensor plate with mounting accessories
• 1 Manual
• Dust- and waterproof plastic housing
• Size incl. bracket 70 x 131 x 62 mm(WxHxD)
• Keypad with 4 buttons
• 15 mm backlit LCD display
• Moisture range 9 to 70 %
• Resolution 0.1 %
• Accuracy +/- 0,8 % for lower moister values
• Ongoing display of the measured value
• Display of average values in adjustable intervals (1, 2 or 5 seconds)
• Manual averaging
• Manual counting
• Power supply 12 to 24 V
• Round sensor plate of high-strength plastic
• Outer diameter of 110 mm with peripheral fase 10 mm
• Thickness 8 mm
• Mounting screws, washers and nuts made of stainless steel
• Insolating discs and spacers made of plastic
• 12 m coaxial cable between the display and the sensor plate
• Waterproof connectors
• 2 m Power supply cable with fuse
Accessories
Spare PFM II sensor plate
Spare PFM II sensor cable
FAQ
The sensor plate of AGRETO PFM II is built in directly into the baler. On display in the cab you can read the moisture in the bale during the pressing process.
Yes, there are no restrictions.
In a round baler, the sensor is mounted at a free position in the lower third in a side wall of the compression chamber or the tailgate (left or right). This location must be accessible for the installation work from the inside and the outside.
In a square baler, the sensor is mounted at a free location in a side wall of the press channel at half height and about 0.5 meters before the end of the pressing channel. The location must be accessible for installation work from the inside and the outside. If the pressed material is cut on one side, mount the sensor on the other side, where the material to be pressed is not cut.
No, the pressed material at these locations is not uniformly compacted, this leads to incorrect results.
Reviews
There are no reviews yet.